The Tablet Stand is designed for a great checkout experience for you and your customers. It rotates and tilts to support different counters and heights – you can even fix the stand to your countertop for a clean, professional setup.
Getting started
How do I mount my tablet in the stand?
How do I mount my tablet in the stand?
Make sure the stand’s housing is set correctly for your tablet.
• The stand arrives already prepared for an Apple iPad.* If you have an iPad, you’re ready for step 3.• If you have an iPad Air:
Remove the top left bumper pad, and then move the three other pads to the correct position – see the illustration for more detail. If the adhesive is not sufficient, use one of the extras found on the stand’s left-hand side.
With the stand in its upright position, insert your tablet's power cable into the stand’s opening. Flip the stand over or on its side and pull out the cable from the bottom.
Plug the power cable into your tablet and mount the tablet in the stand. For a good fit, make sure the cable follows the printed guide.
Replace the frame, starting at the top and guiding it down into place (use the aligning print on the back of the frame for guidance).
How do I secure my tablet inside the stand?
If you want to lock your tablet in the stand, use the hex key located in the stand’s base. At the bottom right side of the frame, insert the hex key and turn it clockwise to lock. Turn the key anti-clockwise to unlock.
How do I mount the stand to a countertop?
Use the provided drill template and two (2) M4 screws with sufficient length for your counter and the stand.
Place the drill template on the surface where you want the stand to be positioned. Use a 5 mm drill and drill two holes through the surface.
Place the stand over the drilled holes, lining it up with its screw inserts. Insert the screws from below and tighten.
Can I hide the tablet cable?
Yes, you can drill an additional hole in your counter at the middle of the stand and wire the cable through. By doing this you can tuck the cable out of sight and maintain a tidier space. Just make sure you use a sufficient drill size to fit and avoid damaging the cable.
Can I power the tablet on/off using the stand?
Yes, if you have mounted your tablet correctly (with its power button in the top left corner), you can use the button on the frame to power your tablet on and off.
How do I adjust the stand to fit my tablet?
How you adjust the stand depends on which tablet you have. Note that the Tablet Stand is optimised for the Apple iPad and iPad Air.
iPad
The stand arrives already prepared for an 8th or 9th Generation (2020 or 2021) iPad. Four bumper pads should be used/placed as in the illustration.
iPad Air
If you have a 4th or 5th Generation (2020 or 2022) iPad Air, you can adjust the fit. Remove the top left bumper pad, and then move the three other pads to the correct position.
If the adhesive is not sufficient to reattach the pads, use one of the extras found on the stand’s left-hand side. See the illustration for more detail.
How much can I rotate and tilt the Tablet Stand?
355° rotation
40° tilt
Compatibility
The Tablet Stand is designed for:
Apple iPad 8th Gen (2020)
Apple iPad 9th Gen (2021)
Apple iPad Air 4th Gen (2020)
Apple iPad Air 5th Gen (2022)
Can I use a different tablet other than the iPad models listed?
Yes, if the dimensions of the tablet are similar enough to the iPad models the Tablet Stand is optimised for.
*Apple, iPad, and iPad Air are trademarks of Apple Inc., registered in the U.S. and other countries and regions.